ABORT
Section: Linux Programmer's Manual (3)Updated: 2017-11-26
Index Return to Main Contents
NAME
abort - cause abnormal process terminationSYNOPSIS
#include <stdlib.h> void abort(void);
DESCRIPTION
The abort() first unblocks the SIGABRT signal, and then raises that signal for the calling process (as though raise(3) was called). This results in the abnormal termination of the process unless the SIGABRT signal is caught and the signal handler does not return (see longjmp(3)).If the SIGABRT signal is ignored, or caught by a handler that returns, the abort() function will still terminate the process. It does this by restoring the default disposition for SIGABRT and then raising the signal for a second time.
RETURN VALUE
The abort() function never returns.ATTRIBUTES
For an explanation of the terms used in this section, see attributes(7).Interface | Attribute | Value |
abort() | Thread safety | MT-Safe |
NOTES
Up until glibc 2.26, if the abort() function caused process termination, all open streams were closed and flushed (as with fclose(3)). However, in some cases this could result in deadlocks and data corruption. Therefore, starting with glibc 2.27, abort() terminates the process without flushing streams. POSIX.1 permits either possible behavior, saying that abort() "may include an attempt to effect fclose() on all open streams".CONFORMING TO
SVr4, POSIX.1-2001, POSIX.1-2008, 4.3BSD, C89, C99.SEE ALSO
gdb(1), sigaction(2), assert(3), exit(3), longjmp(3), raise(3)COLOPHON
This page is part of release 4.15 of the Linux man-pages project. A description of the project, information about reporting bugs, and the latest version of this page, can be found at https://www.kernel.org/doc/man-pages/.
Index
This document was created by man2html, using the manual pages.
Time: 04:45:39 GMT, September 16, 2022
0 댓글